Wireless Testbench
Wireless Testbench allows you to test wideband wireless systems and perform spectrum monitoring with high-speed data capture using MATLAB and USRP™ N3xx, X3xx, or X4xx. You can configure waveform-specific characteristics in hardware to trigger data capture for post-processing and analysis in MATLAB. The tool supports hardware-based resampling to transmit and capture custom signals at arbitrary sample rates, or standards-based signals (5G, WLAN) at their native rates. Additionally, you can integrate custom IP blocks with RF Network-on-Chip (RFNoC™) into the USRP FPGA signal processing chain using HDL Coder.
High-Speed Transmit and Capture
Perform full-rate data transmission and capture up to 250 Msps on supported USRP devices. Test wideband wireless systems and conduct spectrum monitoring.
USRP Hardware Support
Connect MATLAB to USRP X4xx, X3xx, and N3xx radios from Ettus Research™, a National Instruments® brand.
Intelligent Signal Capture
Capture and analyze data by defining waveform-specific characteristics to trigger signal capture.
USRP FPGA Targeting
Design and integrate custom IP blocks into your signal processing chain on the USRP FPGA using HDL Coder.
Fast Resampling
Work with standards-based signals at their native sample rates and custom signals at arbitrary sample rates by performing resampling on FPGAs.
Data Capture for AI Applications
Capture data at sample rates up to 250 Msps and use it to train deep learning models for wireless applications.
